Knowledgebase
Gavita International > Helpdesk > Knowledgebase

Search help:


» Category: Pro-line HID ballasts  (Go back)

» Articles in this category:

 
Can I used double ended Metal Halide lamps in my Pro 1000W fixture? Article rated 3.8/5.0
No. Our Pro-line fixtures and ballasts have been specifically developed to drive HPS lamps. Using a MH lamp in a high frequency HPS ballast can be very dangerous, as the HPS ballasts do not have a tim...
Which lamps can I use for the Pro-line ballasts? Article rated 3.2/5.0
The Pro-line series comprises of high frequency balllasts which power high voltage lamps. Only use the recommended 600W 400V EL (Electronic) lamps or the Gavita Pro 600 EL lamps for the Pro 600,  ...
My Pro 600 ballast isn't starting. What should I check? Article rated 2.9/5.0
Please check the following:   1. Contactor
How often should I replace my Pro-line HR96 reflector? Article rated 3.4/5.0
Miro Aluminum reflectors don't oxidize but they get dirty by dust and deposits that are almost impossible to remove without damaging the reflective material. Calcium deposits (from damp and water), pe...
Can I use the dim function for climate control? Article rated 3.7/5.0
Light is responsible for photosynthesis and dimming the light will decrease photosynthesis and ultimately your yield. If you are not over-saturating your plants with light then you should try to keep ...
Are there MH lamps available for the Pro 600 and Pro 1000? Article rated 3.6/5.0
No, there are not. Both ballasts have been designed for very high frequency HPS lamps, and for 400V lamps specifically, not for normal HPS lamps or MH lamps. So there is no MH equivalent for the Pro 6...
How many BTU do I need for cooling the complete fixtures? Article rated 4.0/5.0
Safe average values for cooling the Pro-line complete fixtures are: Pro 600 - 2600 BTU Pro 1000 - 4000 BTU There is not a lot of difference between the complete fixture and a remote lamp, as th...